![]() 2 Propane tanks & regulator w/pressure gauge under helmseat. Fabricated wooden form fitting bracket, screwed to fibre- glass. Secured tanks with strong bungee cords. Open air location does not require venting. |
![]() Propane regulator & shut-off solenoid located outside of boat. Shut-off solenoid required for safety - will also shut off with loss of 12V power. |
![]() 6 switch fused 12V panel replaced with Blue Sea model 335458, 13 position panel with volt & amp meters. Mounted on separate board. Hinged on left, rotary latch on right. |
![]() New "Hot & Cold" facet behind sink instead of original location beside sink. |
![]() Pressure water pump & accumulator under sink on bulkhead next to icebox. |
![]() Atomic 4 with Perko raw water strainer. 2ft hose on left could be taken off the strainer and put into bilge water for an emergency bilge pump. Strainer mounted above water to clean without sinking boat. |
![]() New Seaward "Princess" 3 burner propane stove. |
![]() AC switch panel and 1 outlet. On the teak panel is the on/off switch for the propane solenoid in Photo #2 |
![]() 700 watt GE Microwave - $59.95 at Sam's Club |
![]() Faucet on the head sink - cold water at this time. |
![]() Raymarine ST60 Tridata and Wind System. This left 2 side by side 4" holes. Rather than filling them in, an opening port was added. 3 days to do the job. |
![]() Same as photo beside. |
![]() 1/2" (maybe 3/8") Lexan hatch board. |
![]() 15 amp 2-battery charger. |
![]() 6 gallon Seaward water heater. Battery charger had to be moved to make room. |
![]() Barient Self tailing primary winches & 1/4" aluminum instrument panel. AC shore power inlet, mounting bracket and 12V connection for Simrad WP5000 Wheel Pilot. |
![]() Same as above - right. |